EBMBMG2Z 2/2-way Solenoid Valve combined operated diaphragm sealed


Brass

Stainless steel

Seat valve with diaphragm sealing

EU-Declaration by the manufacturer

as defi ned by Machinery Directive 89/392/EEC, Annex II B, we herewith declare that the solenoid valves have been developed and designed by applying the following harmonised standards:

  • EN ISO 12100: 2004 Safety of machinery
  • EN 983: 1996 Safety requirements for fl uid power systems and components - Pneumatics
  • EN 60204-1: 1992 Electrical equipment of machinery

 

Advice

These solenoid valves are intended to be incorporated into machinery compounds. Putting into operation of the machinery is not allowed until such time as the entire machinery is proving to comply completely with the EU Directive.

Advice regarding the EU Directive

Suitable wiring of the valve must assure that the limit values given by the harmonised standards EN 80081-1 and EN 50082-1 are being respected, thus fulfi lling the requirements of Directive 89/336/EEC (electromagnetic consistency)

Description

SPECIFICATION

DESIGN

Seat valve with diaphragm sealing

OPERATION

2/2-ways. Combined operation. Normally closed. When the coil is energized the plunger opens the pilot seat (in the middle of the diaphragm) fi rst and then the diaphragm directly (if existing, with help of the pressure difference). When the coil is de-energized the spring closes the pilot seat fi rst and then presses the diaphragm back on top of the main valve seat.

MATERIAL

 

  • Body: Brass, St. steel (up to ½")
  • Internal parts: Stainless steel, brass and PVDF
  • Sealing: NBR (FPM on request)

 

 

CONNECTION

Female thread G1 /4 up to G2 (DIN ISO 228 T1)

CABLE CONNECTION

With connector acc. to EN175301-803

VOLTAGES

  • 24 V direct current (DC)
  • 24, 110, 230 V 50Hz (AC) only with connector with rectifier

 

POWER CONSUMPTION

  • DC = 12 W - 40W
  • AC = 20/16 VA - 45/45 VA, see table overleaf

 

DUTY CYCLE

100%

PROTECTION

IP 65 acc. to EN 60529

PRESSURE RANGE

0 up to max. 16 bar, see table overleaf Sealing FPM max. 10 bar

MEDIA

Gases and liquids up to 25 mm2 /s

TEMPERATURE RANGE

-10°C up to + 90°C

0°C bis +110°C (FPM Sealing)

TEMPERATURE OF THE ENVIRONMENT

-10°C up to +50°C

Attention: At standard coils the temperature of the coil could raise up to 155 °C dependent on the operating conditions.

INSTALLATION

Optional; perferably solenoid vertical on top.

 

The above information is intended for guidance only and the company reserves the right to change any data herein without prior notice!

Specifications

Principe
Control Electric
medium Water en andere vloeistoffen, Lucht, gas en damp, water, olie, lucht
Material Stainless Steel, Brass
Nominal diameter 1/4", 3/8", 1/2", 3/4", 1", 1 1/4", 1 1/2", 2"
Process Connection thread G "
Werkingswijze Dwang gestuurd
Brand Ebora
Hygienic
Ask a quotation for this product

© 2012-2019 Ebora Process Automation is a trademark of Ebora BV - 't Veld 3 - S, Heteren, Netherlands - info@ebora.nl